Description
If any of the following operations are performed, the initialization is necessary for normal operation of anti-pinch function. Refer to Work Procedure.
-
When each power window motor replaced.
-
Power supply to the each power window motor is not cut off properly.
-
Removal and installation of regulator assembly.
-
Removal and installation of each power window motor from regulator assembly.
-
Operation of regulator assembly as an independent unit.
-
Removal and installation of door glass.
-
Removal and installation of door glass run.
Work Procedure
CHECK ANTI-PINCH FUNCTION
-
Fully open the door glass.
-
Place a piece of wood near fully closed position.
-
Close door glass completely with AUTO UP.
-
Check the following conditions.
-
Check that door glass lowers for 145 mm (5.71 in) without pinching piece of wood and stops.
-
Check that door glass does not rise when operating the power window main switch while lowering.
CAUTION:
-
Perform system initialization when AUTO UP operation or anti-pinch function does not operate normally.
-
Check that AUTO-UP operates before inspection when system initialization is performed.
-
Never check with hands and other body parts because they may be pinched. Never get pinched.
-
-
>>
END
Other materials
How to park with predictive course lines
Basic information
WARNING
If the Nissan Armada is equipped with tires of a different size than
standard, the predictive course lines may become inaccurate.
On slippery or snow-covered roads, the Nissan Armada predictive course
lines may not correspond precisely to the actual path of the ...
Precautions for Pop up Engine Hood
PRECAUTIONS FOR POP UP ENGINE HOOD : Precautions
WARNING:
Always observe the following items for preventing accidental activation.
Before removal or installation of the pop-up engine hood and harness, always OFF the ignition switch, disconnect the battery negative terminal, and wait for 3 minutes ...
Additional Service When Replacing Ecm
Description
Performing the following procedure can automatically activate recommunication of ECM and Intelligent Key unit, but only when the ECM is replaced with a new one*. For details, refer to Work Procedure.*: New one means a virgin ECM that has never been energized on-board.(In this step, initi ...