General Specifications
BRAKE SYSTEM
Unit: mm (in)
| Front brake | Cylinder bore diameter | 50.8 × 2 (2.000 × 2) | |
| Pad length × width × thickness | 151.6 × 53.2 × 12.0 (5.97 × 2.094 × 0.47) | ||
| Rotor outer diameter × thickness | 350.0 × 30.0 (13.78 × 1.18) | ||
| Rear brake | Cylinder bore diameter | 48.1 (1.894) | |
| Pad length × width × thickness | 120.1 × 40.9 × 10.0 (4.73 × 1.610 × 0.39) | ||
| Rotor outer diameter × thickness | 350.0 × 20.0 (13.78 × 0.79) | ||
Brake Pedal
Unit: mm (in)
| Item | Standard | |
|---|---|---|
| Brake pedal height | 157.9 – 167.9 (6.22 – 6.61) | |
|
Depressed brake pedal height [Depressing 490 N (50 kg, 110 lb) while engine ON] |
145.0 (5.71) or more | |
| Clearance between stop lamp switch mounting bracket and the brake pedal lever | 14.0 – 18.0 (0.55 – 0.71) | |
| Brake pedal play | 2 - 6 (0.08 - 0.24) | |
Front Disc Brake
Unit: mm (in)
| Item | Limit | |
|---|---|---|
| Brake pad | Wear thickness | 2.0 (0.079) |
| Disc rotor | Wear thickness | 27.4 (1.079) |
| Thickness variation (measured at 8 positions)* | 0.006 (0.0002) | |
| Runout (with it attached to the vehicle) | 0.035 (0.0014) | |
*To check if rotor imbalance, rotor runout or rotor deformation is occurred.
Rear Disc Brake
Unit: mm (in)
| Item | Limit | |
|---|---|---|
| Brake pad | Wear thickness | 1.5 (0.059) |
| Disc rotor | Wear thickness | 18.5 (0.728) |
| Thickness variation (measured at 8 positions)* | 0.009 (0.0004) | |
| Runout (with it attached to the vehicle) | 0.07 (0.0028) | |
*To check if rotor imbalance, rotor runout or rotor deformation is occurred.
Electrical Brake Control Unit
Unit: mm (in)
| Item | Standard |
|---|---|
| Input rod length | 179.7 − 180.7 (7.07 − 7.11) |
Other materials
Basic information
The Nissan Armada driving recorder system is designed to capture high-quality
video and photo footage from both the front and rear of the vehicle, providing an
additional layer of safety, documentation, and convenience. All recorded content
can be easily accessed and reviewed directly on the N ...
Front Oil Seal
Exploded View
Front output shaft
Front oil seal
Front case
Snap ring
Sprockets with chain
Snap ring
Rear case
Rear companion flange
O-ring
: Always replace after every disassembly.
: N·m (kg-m, ft-lb)
: Apply transfer fluid.
: Apply Genuine Liquid Gas ...
Writing of Calibration Data
Work Procedure
DESCRIPTIONIf only the around view monitor control unit is replaced, the calibration data stored in the camera can be written to the around view monitor control unit by selecting "Camera Calibration" of "Work Support" mode in CONSULT.WORK PROCEDUREWRITE CALIBRATION DATA
With CONSULT
...