Description
CAUTION:
Always perform the decel G sensor calibration and side G sensor calibration before driving when the following operation is performed. Refer to Work Procedure.
×: Required —: Not required
| Procedure |
|
|---|---|
| Removing/ installing ABS actuator and electric unit (control unit) | × |
| Replacing ABS actuator and electric unit (control unit) | × |
| Removing/installing steering components | — |
| Replacing steering components | — |
| Removing/installing front suspension components | — |
| Replacing front suspension components | — |
| Removing/installing tire | — |
| Replacing tire | — |
| Tire rotation | — |
| Adjusting front wheel alignment. | — |
Work Procedure
CAUTION:
Always use CONSULT for the decel G sensor calibration and side G sensor calibration. (It cannot be adjusted other than with CONSULT.)
CHECK THE VEHICLE STATUS
-
Steer the steering wheel to the straight-ahead position. Stop the vehicle on level surface.
-
Stop the engine.
-
Ignition switch OFF (Auto ACC function OFF).
Is the vehicle stopped in the straight-ahead position on level surface?
YES>>GO TO 2.
NO>>Steer the steering wheel to the straight-ahead position. Stop the vehicle on level surface.
PERFORM DECEL G SENSOR CALIBRATION, SIDE G SENSOR CALIBRATION
CAUTION:
-
Never allow passenger or load on the vehicle.
-
Never apply vibration to the vehicle body when opening or closing door during calibration.
With CONSULT
-
Ignition switch ON.
CAUTION:
Never start engine.
-
Select “ABS”, “Work support”, "Decel/side G sensor calibration" in this order.
-
Select “START”.
-
After approximately 10 seconds, select “END”.
-
Ignition switch OFF (Auto ACC function OFF) and then it ON again.
CAUTION:
Be sure to perform the operation above.
>>
GO TO 3.
CHECK DATA MONITOR
With CONSULT
-
Drive the vehicle. Steer the steering wheel to the straight-ahead position. Stop the vehicle on level surface.
-
Select “ABS”, "Data monitor", and "Decel/side G sensor calibration" in this order. Check that the signal is within the specified value. Refer to Reference Value.
Is the inspection result normal?
YES>>GO TO 4.
NO>>GO TO 1.
ERASE SELF-DIAGNOSIS MEMORY
With CONSULT
Erase self-diagnosis result of “ABS”.
Are the memories erased?
YES>>End of work.
NO>>Check the items indicated by the self-diagnosis.
Other materials
Unexpected Brake Pedal Reaction
Diagnosis Procedure
A malfunction of brake pedal feel (height or others) is detected when the brake pedal is depressed.CHECK AXLE
Check that there is no significant looseness of axle.
Front axle
2WD models: Refer to Inspection.
4WD models: Refer to Inspection.
Rear axle: Refer to Inspectio ...
For Side and Rollover Collision
When SRS is activated in a collision
CAUTION:
Due to varying models and option levels, not all parts listed in the chart below apply to all Nissan Armada vehicles.WORK PROCEDURE
Before performing any of the following steps, ensure that all vehicle body and structural repairs have been completed.
...
Diagnosis and Repair Work Flow
Work Flow
OVERALL SEQUENCEDETAILED FLOWGET INFORMATION FOR SYMPTOM
Get detailed information from the customer about the symptom (the condition and the environment when the incident/malfunction occurs).
Check operation condition of the function that is malfunctioning.
>>
GO TO 2.
CHECK ...