Removal and Installation
REMOVAL
CAUTION:
Never reuse combination switch. Always replace it with a new one when it is removed.
Remove spiral cable. Refer to Removal & Installation.
Disconnect harness connector from combination switch.
Remove the combination switch 
mounting screw 
.
Pull out the combination switch by moving it alternately on the right and left side.
CAUTION:
Never deformation and damage the pawls. (With ProPILOT Assist 2.1)
 |
: Pawl |
INSTALLATION
Note the following, and then install in the reverse order of removal.
CAUTION:
-
Never reuse combination switch. Always replace it with a new one when it is removed. (Without ProPILOT Assist 2.1)
-
Visually check the pawls for deformation and damage during installation. Replace with new ones if necessary. (With ProPILOT Assist 2.1)
-
Insert the combination switch so that the protrusion
of the combination switch and the cut-out 
of the steering column 
match together.
Other materials
Basic information
Drive Mode Selector (example)
Vehicle information display (example)
The Nissan Armada features a versatile Drive Mode Selector system that allows
the driver to tailor vehicle performance to different driving conditions. By rotating
the selector dial to the left or right, you can quickl ...
Sunshade Does Not Operate Properly
Description
Sunshade does not operate normally.
Sunshade OPEN/CLOSE does not operate.
Sunshade OPEN/CLOSE operation is slow.
Judder occurs during OPEN/CLOSE operation of sunshade.
Diagnosis Procedure
CHECK SUNSHADE
Check sunshade for damage, deformation, of interference with other parts.
Is ...
Front Disc Brake
Brake Pad
Inspection and Adjustment
WARNING:
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System ...