Nissan Armada owner resource

Manuals, service information and practical owner guidance.

Fast access to Nissan Armada manuals, operating instructions, maintenance references and technical information.

Browse manuals
Nissan Armada manual library

Nissan Armada 2025-2026 Service and Repair Manual: Configuration (bcm)

Description

Vehicle specification needs to be written with CONSULT because it is not written after replacing the BCM.

The configuration requires network connection. CONSULT connects to network and then it downloads the configuration data from the server. Then CONSULT writes the vehicle specification to the BCM.

Refer to Work Procedure.

NOTE:

For details the network connection and operation, refer to “CONSULT Operation Manual”.

The configuration no need to “save” configuration data from the BCM. The configuration data is always generated freshly at the server and then downloaded to the CONSULT.

CAUTION:

  • Complete the procedure of “Configuration” in order.

  • If incorrect “Configuration”, incidents might occur.

  • Never perform “Configuration” except for new BCM.

Work Procedure

WRITING VEHICLE SPECIFICATION

With CONSULT

  1. Ignition switch ON.

  2. Perform writing vehicle specification to BCM following "Automatic Configuration" procedure of "Configuration" according to CONSULT Operation Manual.

NOTE:

  • Log in the network according to CONSULT guidance.

  • For details the network connection and operation, refer to “CONSULT Operation Manual”.

>>

WORK END

    Other materials

    Noise, Vibration and Harshness (nvh) Troubleshooting
    NVH Troubleshooting Chart Use chart below to find the cause of the symptom. If necessary, repair or replace these parts. Possible cause and SUSPECTED PARTS Symptom Reference DRIVE SHAFT FRONT AXLE Noise Shake Noise Shake Vibration Shimmy Judder Poor quality ride or handling Excessive ...

    Aeb System Symptoms
    Symptom Table Symptom Confirmation item Reference page AEB system display does not display Combination meter On Board Diagnosis Function AEB OFF warning lamp is blinking The distance sensor area of the front of the vehicle is covered with dirt or is obstructed The interior temperat ...

    Sunshade
    Exploded View Refer to Exploded View. Removal and Installation REMOVALRemove rear moonroof glass. Refer to Removal and Installation. Disengage sunshade stay using a remover tool (B) from sunshade slider as shown by the arrow in the figure. CAUTION: Apply protective tape (C) on remover tool to pro ...