Nissan Armada 2025-2026 Service and Repair Manual: Configuration (bcm)

Nissan Armada 2025-2026 Service and Repair Manual / Electrical & Power Control / Body Control System — Basic Inspection / Configuration (bcm)

Vehicle specification needs to be written with CONSULT because it is not written after replacing the BCM.

The configuration requires network connection. CONSULT connects to network and then it downloads the configuration data from the server. Then CONSULT writes the vehicle specification to the BCM.

Refer to Work Procedure.

NOTE:

The configuration no need to “save” configuration data from the BCM. The configuration data is always generated freshly at the server and then downloaded to the CONSULT.

CAUTION:

Complete the procedure of “Configuration” in order.

If incorrect “Configuration”, incidents might occur.

Never perform “Configuration” except for new BCM.

Work Procedure

Work Procedure

REPLACE BCM Replace BCM. Refer to Removal and Installation. >> GO TO 2. WRITING Vehicle SPECIFICATION Perform configuration (BCM). Refer to Description. >> GO TO 3. PAIRING OF BCM AN ...

WRITING VEHICLE SPECIFICATION With CONSULT Ignition switch ON. Perform writing vehicle specification to BCM following "Automatic Configuration" procedure of "Configuration" according to CONSULT Operat ...

Other materials:

Anti-corrosive Treatment
Anti-corrosive treatment may be performed on three different occasions (before welding, before painting, and after painting). This section explains anti-corrosive treatment for the latter two occasions. (1) ANTI-CORROSIVE TREATMENT BEFORE PAINTING Application of body sealer Body sealer prevents wate ...

Welding of Automobile Body
The automobile body is fabricated by welding 0.6 mm - 1.4 mm (0.024 in - 0.055 in) thick sheet steel. Spot welding is most suitable in terms of cost, quality and working efficiency. On the automobile production line, spot welding is widely used, except for some special areas which cannot use this pr ...

Removal and Installation
REMOVAL Remove emblem from the panel while warming using an industrial dryer. CAUTION: Never damage the painted surface of the panel when removing. INSTALLATION Note the following items, and then install in the reverse order of removal. CAUTION: Never reuse the emblem which was peeled. Degrease the ...

0.0049