Nissan Armada 2025-2026 Service and Repair Manual: Welding of Automobile Body
The automobile body is fabricated by welding 0.6 mm - 1.4 mm (0.024 in - 0.055 in) thick sheet steel. Spot welding is most suitable in terms of cost, quality and working efficiency. On the automobile production line, spot welding is widely used, except for some special areas which cannot use this procedure. Today, spot welding is mostly performed by robots.
In addition to spot welding MAG brazing are also used.
Soldering is not used in the automobile production line.
Automobile assembly line welding processes are shown below.
Safety Section
The occupational safety regulations include provisions on preventative measures for avoiding damage and accidents. As the occupational safety regulations are country- specific, this document only list ...
Other materials:
Work Procedure
After replacing the ADAS control unit 2 and after replacing or removing the following steering components, the steering torque calibration is necessary to operate the system normally.
Steering wheel
Spiral cable
Steering angle sensor
Steering column assembly
Steering gear assembly
NOTE:
Follow the ...
Disassembly and Assembly
CAUTION:
OUTSIDE SEAT CUSHION FINISHER OUTER
Disassembly
Disengage fixing pawls, and then remove reclining knob cap.
: Pawl
Disengage fixing portion using a remover tool (A) according to numerical order 1→2 indicated by arrows as shown in the figure, and then remove reclining knob.
Remove ...
Removal and Installation
REMOVAL
Remove driver knee air bag module. Refer to Removal and Installation.
Remove BCM. Refer to Removal and Installation.
Remove fuse block (J/B).
Disconnect the stop lamp switch harness connectors.
Remove stop lamp switch , follow the procedure below.
Rotate the stop lamp switch counterclockwi ...
0.0061