Nissan Armada owner resource

Manuals, service information and practical owner guidance.

Fast access to Nissan Armada manuals, operating instructions, maintenance references and technical information.

Browse manuals
Nissan Armada manual library

Nissan Armada 2025-2026 Service and Repair Manual: Diagnosis and Repair Work Flow

Work Flow

OVERALL SEQUENCE

DETAILED FLOW

INTERVIEW FOR MALFUNCTION

It is also important to clarify the customer concerns before starting the inspection. Interview the customer about the concerns carefully and understand the symptoms fully.

NOTE:

The customers are not professionals. Never assume that “maybe the customer means···” or “maybe the customer mentioned this symptom”.

>>

GO TO 2.

SELF-DIAGNOSIS WITH CONSULT

  1. Perform “All DTC Reading” with CONSULT.

  2. Check if the DTC is detected on the self-diagnosis results of following.

    • “ICC/ADAS 2”

Is any DTC detected?

YES>>

Record or print self-diagnosis results and freeze frame data (FFD).GO TO 5.

NO>>

GO TO 3.

ACTION TEST

Perform RAB system action test to check the operation status. Refer to Work Procedure.

Check if any other malfunctions occur.

>>

GO TO 4.

SYMPTOM DIAGNOSIS

Perform the applicable diagnosis according to the diagnosis chart by symptom. Refer to Symptom Table.

>>

GO TO 6.

TROUBLE DIAGNOSIS BY DTC

  1. Erase self-diagnostic results.

  2. Ignition switch OFF → ON.

    CAUTION:

    Be sure to wait of 10 seconds after turning ignition switch OFF or ON.

  3. Check the DTC in the self-diagnosis results.

  4. Perform trouble diagnosis for the detected DTC following.

    • “ICC/ADAS 2”(Without ProPILOT Assist 2.1): Refer to DTC Index.

    • “ICC/ADAS 2”(With ProPILOT Assist 2.1): Refer to DTC Index.

NOTE:

If “DTC: U1000–01” is detected, first diagnose the CAN communication system.

>>

GO TO 6.

MALFUNCTIONING PART REPAIR

Repair or replace the identified malfunctioning parts.

>>

GO TO 7.

REPAIR CHECK (SELF-DIAGNOSIS WITH CONSULT)

  1. Erases self-diagnosis results.

  2. Perform “All DTC Reading” again after repairing or replacing the specific items.

  3. Check if any DTC is detected in self-diagnosis results of following.

    • “ICC/ADAS 2”

Is any DTC detected?

YES>>

GO TO 5.

NO>>

GO TO 8.

REPAIR CHECK (ACTION TEST)

Perform the RAB system action test. Check that the malfunction symptom is solved or no other symptoms occur.

Is there a malfunction symptom?

YES>>

GO TO 4.

NO>>

INSPECTION END

    Other materials

    Transfer Assembly
    Exploded View Transfer assembly : N·m (kg-m, ft-lb) Removal and Installation WARNING: Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Li ...

    Rear Cooler Pipe Assembly
    Removal and Installation REMOVALCAUTION: Perform lubricant return operation before each refrigeration system disassembly. However, if a large amount of refrigerant or lubricant leak is detected, never perform lubricant return operation. Refer to Perform Lubricant Return Operation. When disconnec ...

    Outside Key Antenna
    Rear Door Removal and Installation REMOVALRemove rear door finisher. Refer to Removal & Installation. Disconnect outside key antenna (rear door) harness connector. Disengage outside key antenna (rear door) fixing clips, and then remove outside key antenna (rear door) . : Clip Disengage ...