Nissan Armada 2025-2026 Service and Repair Manual: Diagnosis Procedure
CHECK ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)
With CONSULT
Start the engine.
CAUTION:
The vehicle must be in a stopped state.
Connect booster battery (12V) and jumper cable to 12V battery cable.
Select “Active test” in “ENGINE”.
Select “Auto stop start” in “Active test”.
Touch “Start”.
CAUTION:
Since the engine runs with the hood open, special care must be taken when performing the work.
If the idling stop state cannot be developed. Refer to System Description.
Check the ABS warning lamp state and the brake warning lamp state when “Cancel” is touched under the idling stop state.
Are the VDC warning lamp, ABS warning lamp and the brake warning lamp OFF?
YES>>Check the 12V battery. Refer to Work Flow.
NO>>GO TO 2.
PERFORM THE SELF-DIAGNOSIS
With CONSULT
Turn the ignition switch OFF → ON.
CAUTION:
Be sure to wait of 10 seconds after turning ignition switch OFF or ON.
Start the engine.
Repeat step 1 two or more times.
Perform self-diagnosis for “ABS”.
Is any DTC detected?
YES>>Check the DTC. Refer to DTC Index.
NO>>INSPECTION END
Vdc Warning Lamp, Abs Warning Lamp and Brake Warning Lamp Turn on
ABS warning lamp and Brake warning lamp turn ON for a moment when restating the engine. ...
Normal Operating Condition
Symptom Result Brake pedal slightly vibrates and operation sound (motor sound and sound from suspension) occurs when VDC function, TCS function, ABS function, EBD function, brake limited slip diffe ...
Other materials:
Special Service Tool
The actual shape of the tools may differ from those illustrated here.Tool number
(TechMate No.)
Tool name Description KV10115801
(NI-38956)
Oil filter wrench
Removing and installing oil filter
a: 64.3 mm (2.531 in)—
(NI-52972–2)
OFT position change wrench
Removing and installing drain plug
Ch ...
Removal and Installation
REMOVAL
Remove front heater & cooling unit assembly. Refer to Removal and Installation.
Remove front heater core. Refer to Removal and Installation.
Remove front expansion valve. Refer to Removal and Installation.
Disconnect front mode door motor harness connector .
Remove sub harness from fro ...
ROAD WHEEL : Service Data
ALUMINUM WHEEL
Item Limit Runout Axial runout 0.3 mm (0.012 in) or less Radial runout Allowable unbalance Dynamic (At flange) 5 g (0.17 oz) or less (one side) Static (At flange) 10 g (0.35 oz) or less
ALUMINUM WHEEL (EMERGENCY)
Item Limit Runout Axial runout (Average) 0.3 mm (0.012 ...
0.0062