REPLACE INTELLIGENT KEY UNIT
Replace Intelligent Key unit. Refer to Removal and Installation.
Confirm the operation after replacement.
Is the result normal?
YES>>INSPECTION END
NO>>Check intermittent incident. Refer to Intermittent Incident.
Exploded View
Bracket Side oil seal Rear final drive assembly Differential lock position switch Rear cover Gasket Drain plug Stud bolt Filler plug O-ring : N·m (kg-m, in-lb) : N·m (kg-m, ft-lb) : Always replace after every disassembly. : Apply gear oil. : Apply Genuine Liquid Gasket, Three Bond 1217 ...
EVAP CANISTER : Inspection
Check EVAP canister as per the following:
Block port .
Blow air into port and check that it flows freely out of port .
Release blocked port .
Apply vacuum pressure to port and check that vacuum pressure exists at the ports and .
Block port and .
Apply pressure to port and check that there is ...
Removal & Installation
WARNING:
REMOVAL
Remove valve timing control covers (bank 1 and bank 2) and gasket as follows:Disconnect valve timing oil control solenoid valve (bank 1 and bank 2) harness connector. Loosen valve timing control cover mounting bolts in the order from 4 to 1 as shown in the figure.
: Bank 1 : Ba ...