CHECK “AUTO DOOR UNLOCK” SETTING IN COMBINATION METER
Check “Auto Door Unlock” setting is “Shift to P”.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Set “Shift to P” in combination meter.
REPLACE BCM
Replace BCM. Refer to Removal and Installation.
Confirm the operation after replacement.
Is the result normal?
YES>>INSPECTION END
NO>>Check intermittent incident. Refer to Intermittent Incident.
Reminder Function Does Not OperateExploded View
Rear bumper side bracket LH Rear bumper bracket RH Rear bumper bracket LH Hands free sensor bracket
(with hands free sensor models) Double-sided tape
[t: 1.2 mm (0.047 in)]
(with hands free sensor models) Rear bumper fascia Rear bumper molding LH Rear bumper finisher upper Rear bumper finish ...
Refilling
WARNING:
The ignition switch OFF.
Recommended fluid and capacity: Refer to Fluids and Lubricants.
CAUTION:
Carefully fill the fluid. (Fill up for approximately 3 minutes.)
Leave the vehicle for 3 minutes, and check the fluid level again.
Install filler plug on transfer and tighten to the specif ...
Exploded View
Idler pulley Alternator Drive belt auto-tensioner Crankshaft pulley A/C compressor Water pump Drive belt A/C compressor belt View Indicator Range when new drive belt is installed Possible use range Always replace after every disassembly. ...