Nissan Armada 2025-2026 Service and Repair Manual: Disposal
Set shock absorber horizontally with the piston rod fully extended.
Drill 2 – 3 mm (0.08 – 0.12 in) hole at the position (
) from top as shown in the figure to release gas gradually.
CAUTION:
Wear eye protection (safety glasses).
Wear gloves.
Be careful with metal chips or oil blown out by the compressed gas.
NOTE:Drill vertically in this direction (
).Directly to the outer tube avoiding brackets.
The gas is clear, colorless, odorless, and harmless.
A : 20 – 30 mm (0.79 – 1.18 in) Position the drilled hole downward and drain oil by moving the piston rod several times.
CAUTION:
Dispose of drained oil according to the law and local regulations.
Adjustment
WITHOUT DYNAMIC DIGITAL SUSPENSION AND ELECTRONIC AIR SUSPENSION
Adjustment After Installation
Adjust neutral position of steering angle sensor. Refer to Work Procedure.
WITH DYNAMIC DIGITAL SUSPENSIO ...
Front Stabilizer
...
Other materials:
Removal and Installation
REMOVAL
CAUTION:
Never use a material for remover tool which could damage body side panel.
Fully open front door and rear door.
Apply a protective tape (A) on the parts to protect it from damage.
Cut double-sided tapes using a remover tool (A) and cutter (B), and then remove parting seal C.
CAUT ...
Diagnosis Procedure
CHECK INTELLIGENT KEY SYSTEM SYMPTOM TABLE
Check Intelligent Key system symptom table. Refer to Diagnosis Procedure.
>>
GO TO 2.
CHECK OUTSIDE KEY ANTENNA
Use SIGNAL TECH II to check each outside key antenna. For the inspection method and how to use SIGNAL TECH II, refer to “NISSAN/INFINIT ...
Inspection
INSPECTION AFTER DISASSEMBLY
Drive Gear and Drive Pinion
Clean up the disassembled parts.
If the gear teeth never mesh or line-up correctly, determine the cause and adjust or replace as necessary.
If the gears are worn, cracked, damaged, pitted or chipped (by friction) noticeably, replace with new d ...
0.006