Nissan Armada 2025-2026 Service and Repair Manual: Inspection
INSPECTION AFTER DISASSEMBLY
Drive Gear and Drive Pinion
Clean up the disassembled parts.
If the gear teeth never mesh or line-up correctly, determine the cause and adjust or replace as necessary.
If the gears are worn, cracked, damaged, pitted or chipped (by friction) noticeably, replace with new drive gear and drive pinion as a set.
Oil Seal
Whenever disassembled, replace.
If wear, deterioration of adherence (sealing force lips), or damage is detected on the lips, replace them.
Differential Assembly
Clean up the disassembled parts.
If any wear or crack is found, replace.
Adjustment
TOTAL PRELOAD TORQUE
Remove side shaft. Refer to Disassembly and Assembly.
Rotate drive pinion back and forth 2 to 3 times to check for unusual noise and rotation malfunction.
Rotate drive pinion at l ...
Drive Pinion
...
Other materials:
Removal and Installation
REMOVAL
2WD Models
Remove glove box assembly. Refer to Removal and Installation.
Remove passenger knee air bag module. Refer to Removal and Installation.
Disconnect A/C auto amp. harness connectors and .
: Vehicle front
Remove fixing screw , and then slide A/C auto amp. in the direction indica ...
Removal and Installation
REMOVAL
Without Dynamic Digital Suspension and Electronic Air Suspension
Remove tires. Refer to ROAD WHEEL TIRE : Removal & Installation.
Remove wheel sensor and harness connector. Move wheel sensor in a place where it will not interfere with work. Refer to Removal and Installation.
Set suitable ...
Removal and Installation
WARNING:
REMOVAL
Remove engine cover. Refer to Removal and Installation.
Remove air inlet tube (1 and 2). Refer to Removal & Installation.
Remove electric throttle control actuator as follows:Drain engine coolant from radiator or attach plug to prevent engine coolant leakage when engine coolant ...
0.0054