Diagnosis Procedure
CHECK SYMPTOM
Check the symptoms.
A stop/start indicator lamp turned on, and did an engine perform a stall at the time of restart from a stop/start system?
YES>>GO TO 2.
NO>>Refer to Symptom Table.
CHECK STOP/START PROHIBIT CAUSE
With CONSULT
Select “Stop/Star engine stall cause data recorder” in “Work support” mode of “ENGINE” using CONSULT.
Is the cause of the engine not starting recorded?
YES>>Eliminate the cause and complete the inspection.
NO>>GO TO 3.
CHECK STARTER MOTOR (SUB STARTER & ALTERNATOR) OPERATION
Check the stater motor (sub starter & alternator *if equiped ) operation when engine restart during stop/start system operation.
Is the starter motor operated?
YES>>Refer to Symptom Table.
NO>>Perform “All DTC Reading” with CONSULT and perform trouble diagnosis for DTC indicated.
Other materials
Noise, Vibration and Harshness (nvh) Troubleshooting
NVH Troubleshooting Chart
Use chart below to find the cause of the symptom. If necessary, repair or replace these parts. Possible cause and SUSPECTED PARTS Symptom Reference
FRONT AXLE
Noise Shake Vibration Shimmy Judder Poor quality ride or handling
Improper installation, looseness
...
Precautions
Precautions for Removing Battery Terminal
When disconnecting the 12V battery terminal, turn off the ACC power before disconnecting the 12V battery terminal, observing “How to disconnect 12V battery terminal” described below.
NOTE:
Some ECUs operate for a certain fixed time even after ignit ...
Hands Free Control Unit
Removal and Installation
REMOVALRemove rear bumper fascia. Refer to Removal and Installation.
Remove bracket cover fixing screws, and then remove bracket cover.
Disconnect hands free sensor harness connectors.
Remove hands free control unit fixing screws, and then remove hands free control unit.
Rem ...