NIARMADA Nissan Armada manuals & owner information
Nissan Armada owner resource

Manuals, service information and practical owner guidance.

Fast access to Nissan Armada manuals, operating instructions, maintenance references and technical information.

Browse manuals →
Nissan Armada manual library

Nissan Armada 2025-2026 Service and Repair Manual: Stop/start System Inoperative

Nissan Armada 2025-2026 Service and Repair Manual / Engine / Engine Control System. Vr35ddtt / Stop/start System Inoperative

Diagnosis Procedure

NOTE:

Check the stop/start system operation condition. Refer to System Description.

CHECK STOP/START PROHIBIT CAUSE

With CONSULT

Select “Stop/Start prohibit cause data recorder” in “Work support” mode of “ENGINE” using CONSULT.

Does "Stop/Start prohibit cause data recorder" show fail-safe?

YES>>

GO TO 2.

NO>>

Check the operating status of system stop / start. Refer to System Description. After confirmation, go to 4.

CHECK "Stop/Start error" OF CONSULT DATA MONITOR ITEM

With CONSULT

  1. Select "Stop/Start error" in "Monitor Menu" of “Data monitor” mode in CONSULT.

  2. Check the displayed data monitor items. Refer to CONSULT Function.

Are there any "NG" monitor items?

YES>>

After confirming the "NG" item, go to 3.

NO>>

GO TO 3.

CHECK DTC

With CONSULT

Perform “All DTC Reading” with CONSULT.

Does it detect the DTC associated with "Stop/Start error" of “Data monitor”?

YES>>

Perform trouble diagnosis of detected DTC. After repairing the defective part, go to 4.

NO>>

GO TO 4.

CHECK STOP/START INDICATOR / LAMP

Check the stop/start indicator / lamp.

WARNING LAMP/INDICATOR LAMP / INDICATOR CONDITION
Stop/start indicator / lamp Not blinking

Is the stop/start indicator / lamp blinking?

YES>>

Refer to Symptom Table.

NO>>

INSPECTION END

    Other materials

    Change of System Mode
    Description CAUTION: When the following operations are performed, always use CONSULT, for performing "System mode change" of "Work support". Refer to Work Procedure.×: Required —: not required Procedure System mode change Removing/installing ABS actuator and electric unit (control unit) ...

    Condenser Inlet Pipe
    Removal and Installation REMOVALCAUTION: Perform lubricant return operation before each refrigeration system disassembly. However, if a large amount of refrigerant or lubricant leak is detected, never perform lubricant return operation. Refer to Perform Lubricant Return Operation. When disconnec ...

    Engine Does Not Start When Intelligent Key Is Inside of Vehicle
    Description Engine does not start when push-button ignition switch is pressed while carrying Intelligent Key.NOTE: Before starting diagnosis check that vehicle condition is as shown in “Conditions of vehicle”, and check each symptom. The engine start function, door lock function, power distr ...