Diagnosis Procedure
Diagnosis ProcedureRemoval and Installation
WARNING:
REMOVAL
Remove rear final drive assembly. Refer to Removal and Installation.
NOTE:
It is necessary to remove rear final drive assembly to remove/install the side oil seal.
Remove side oil seal, using side oil seal puller (A) [SST: KV10122000 (NI-53383)] and sliding hammer (B) (commercial s ...
Exploded View
Bank 1 side
Water inlet hose Clamp Water inlet tube O-ring Heat insulator (upper) Oil return pipe 1 Oil return hose Oil return pipe 2 Heat insulator (lower) Water outlet tube Turbocharger assembly Gasket 1 Stud bolt Oil feed tube Eye bolt Gasket 2 Comply with the installation proc ...
Inspection
INSPECTION AFTER REMOVAL
Examine with eyes that there is no stain, clogging, or damage on air cleaner filter.
Remove dusts (such as dead leafs) on air cleaner filter surface and inside cleaner case.
To clean air cleaner element, blow it from intake manifold side towards air intake side to remove tra ...