Description
The oil control system allows calculating the remaining distance to drive before oil change request. The engine oil data reset must be performed after engine oil is changed. (For details, refer to Work Procedure .)
CAUTION:
Never reset data except when changing engine oil.
NOTE:
Data cannot be reset until the vehicle travels 10 km (6.2 mile) from the previous data reset.
Work Procedure
START
-
Ignition switch ON.
-
Check information display of the combination meter.
Is Distance to Engine Oil Change displayed?
YES>>GO TO 3.
NO>>GO TO 2.
SELECT OIL CONTROL SYSTEM MODE
Push the Display next switch and select oil control system mode.
>>
GO TO 3.
RESET ENGINE OIL DATA
-
Press and hold the Display Next switch at least 1 second while Distance to Engine Oil Change is displayed.
-
Stop pressing the Display Next switch, and a few seconds later, check that the value of Distance to Engine Oil Change is reset.
>>
END
Other materials
Rack End Value Reset
Work Procedure
NOTE:
When steering column assembly and steering gear assembly are replaced, rack end value reset (steering wheel turning angle learning value reset) is performed.
When the toe-in is adjusted, back end value reset (steering wheel turning angle learning value reset) is performed.
...
Rear Seat Belt Warning (information Display) Does Not Operate
Diagnosis Procedure
CHECK DTC OF AIR BAG DIAGNOSIS SENSOR UNIT
Check DTC in “Self Diagnosis Result” mode of “AIR BAG” using CONSULT.
Is DTC detected?
YES>>
Perform trouble diagnosis related to the detected DTC. Refer to DTC Index.
NO>>
GO TO 2.
CHECK COMBINATION METER
Check com ...
Engine Does Not Start When Intelligent Key Is Inside of Vehicle (one Key)
Description
Engine does not start when push-button ignition switch is pressed. (One Intelligent Key has the symptom, other keys operate normally.)SYMPTOM TABLE (ONE INTELLIGENT KEY HAS THE SYMPTOM, OTHER KEYS OPERATE NORMALLY) Door lock operation (remote keyless entry) Door lock operation (request ...