Description
Engine does not start when push-button ignition switch is pressed while carrying Intelligent Key.
NOTE:
-
Before starting diagnosis check that vehicle condition is as shown in “Conditions of vehicle”, and check each symptom.
-
The engine start function, door lock function, power distribution system, and NATS-IVIS/NVIS in the Intelligent Key system are closely related to each other regarding control. The vehicle security function can operate only when the door lock and power distribution system are operating normally.
SYMPTOM TABLE (BOTH INTELLIGENT KEYS HAVE THE SAME SYMPTOMS)
| Door lock operation (remote keyless entry) | Door lock operation (request switch of front/rear door) or trunk/back door open operation (opener switch of trunk/back door panel) | Engine started with push-button ignition switch operation (registered Intelligent Key is within the detection area of inside key antenna) | Engine started with push-button ignition switch operation (registered Intelligent Key placed next to push-button ignition switch) | Unlock operation when approaching the vehicle, lock operation when away from the vehicle (registered Intelligent Key is within the detection area of outside key antenna) |
|---|---|---|---|---|
| OK | OK | No crank, No start | OK | OK |
CONDITIONS OF VEHICLE (OPERATING CONDITIONS)
One or more Intelligent Keys with a registered Intelligent Key ID are in the vehicle.
DIAGNOSIS PROCEDURE
Refer to Diagnosis Procedure.
Diagnosis Procedure
CHECK INTELLIGENT KEY SYSTEM SYMPTOM TABLE
Check Intelligent Key system symptom table. Refer to Diagnosis Procedure.
>>
GO TO 2.
PERFORM SELF-DIAGNOSIS RESULT
With CONSULT
Select “Self Diagnostic Result” mode of “INTELLIGENT KEY”, and check if DTC is detected.
Is DTC detected?
YES>>Perform the trouble diagnosis for the detected DTC.
NO>>GO TO 3.
CHECK INSIDE KEY ANTENNA
Check inside key antenna.
Refer to DTC Diagnosis Procedure.
Is the inspection result normal?
YES>>GO TO 4.
NO>>Repair or replace malfunctioning parts.
CHECK PUSH-BUTTON IGNITION SWITCH
Check push-button ignition switch. Refer to Component Function Check.
Is the inspection result normal?
YES>>GO TO 5.
NO>>Repair or replace malfunctioning parts.
REPLACE INTELLIGENT KEY UNIT
-
Replace Intelligent Key unit. Refer to Removal and Installation.
-
Check operation after replacement.
Is the inspection result normal?
YES>>INSPECTION END
NO>>Check intermittent incident. Refer to Intermittent Incident.
Other materials
Shift Position
Inspection
CHECK SHIFT BUTTON OPERATION
When pressing each shift button of electric shift selector, check that each button is not twisted, stuck, or does not make noise and can be operated smoothly.
After pressing each shift button, check that all buttons return to original positions without sti ...
Refrigeration System Symptoms
Trouble Diagnosis For Unusual Pressure
Diagnose using a manifold gauge whenever system’s high and/or low side pressure(s) is/are unusual. The marker above the gauge scale in the following tables indicates the standard (usual) pressure range. Refer to above table (Ambient air temperature-to-operati ...
Rear Wheel House Protector
Exploded View
Rear wheel house protector
Grommet
U nut
Removal and Installation
WARNING:
REMOVALRemove rear wheel house protector mounting bolts, nuts, and fixing clips, and then remove rear wheel house protector.
Remove U nut from rear wheel house protector.INSTALLATIONInstall in ...