Nissan Armada 2025-2026 Service and Repair Manual: Engine Does Not Start When Intelligent Key Is Inside of Vehicle (one Key)
Engine does not start when push-button ignition switch is pressed. (One Intelligent Key has the symptom, other keys operate normally.)
| Door lock operation (remote keyless entry) | Door lock operation (request switch of front/rear door) or trunk/back door open operation (opener switch of trunk/back door panel) | Engine started with push-button ignition switch operation (Intelligent Key is within the detection area of inside key antenna) | Engine started with push-button ignition switch operation (registered Intelligent Key placed next to push-button ignition switch) | Unlock operation when approaching the vehicle, lock operation when away from the vehicle (registered Intelligent Key is within the detection area of outside key antenna) |
|---|---|---|---|---|
| OK | OK | No crank, No start | No crank, No start | OK |
DIAGNOSIS PROCEDURE
Refer to Diagnosis Procedure.
Diagnosis Procedure
CHECK INTELLIGENT KEY SYSTEM SYMPTOM TABLE
Check Intelligent Key system symptom table. Refer to Diagnosis Procedure.
>>
GO TO 2.
PERFORM SELF-DIAGNOSIS RESULT
With CONSULT
Select “Self Diagn ...
Diagnosis Procedure
CHECK INTELLIGENT KEY SYSTEM SYMPTOM TABLE
Check Intelligent Key system symptom table. Refer to Diagnosis Procedure.
>>
GO TO 2.
REGISTER INTELLIGENT KEY
Register the Intelligent Key.
Check op ...
Other materials:
Securing the Vehicle
To prevent the movement of vehicle, use a suitable method that can resist the pulling force required for repair.
(1) ANCHORING POINT
For passenger vehicle
CAUTION:
Choose the foundation of a rigid pillar or a member for anchoring point.
Set the equipment so that the direction of claw clamp is o ...
Removal and Installation
REMOVAL
Remove hood assembly. Refer to Removal and Installation.
Remove front fender assembly. Refer to Removal and Installation.
Remove hood hinge mounting bolts, and then remove hood hinge.
INSTALLATION
Note the following items, and then install in the reverse order of removal.
CAUTION:
Before ins ...
Removal & Installation
WARNING:
REMOVAL
Remove engine cover. Refer to Removal and Installation.
Remove front under cover using a power tool (commercial service tool). Refer to Removal and Installation.
Remove air inlet tube 1 and air inlet tube 2 of charge air cooler side as follows.Remove mounting bolt of air inlet tube ...
0.0068