Description
The oil control system allows calculating the remaining distance to drive before oil change request. The engine oil data reset must be performed after engine oil is changed. (For details, refer to Work Procedure .)
CAUTION:
Never reset data except when changing engine oil.
NOTE:
Data cannot be reset until the vehicle travels 10 km (6.2 mile) from the previous data reset.
Work Procedure
START
-
Ignition switch ON.
-
Check information display of the combination meter.
Is Distance to Engine Oil Change displayed?
YES>>GO TO 3.
NO>>GO TO 2.
SELECT OIL CONTROL SYSTEM MODE
Push the Display next switch and select oil control system mode.
>>
GO TO 3.
RESET ENGINE OIL DATA
-
Press and hold the Display Next switch at least 1 second while Distance to Engine Oil Change is displayed.
-
Stop pressing the Display Next switch, and a few seconds later, check that the value of Distance to Engine Oil Change is reset.
>>
END
Other materials
Parking Brake Does Not Operate
Description
The parking brake is not applied even when the parking brake switch is pulled.
Diagnosis Procedure
PERFORM THE SELF-DIAGNOSIS
With CONSULT
Perform self-diagnosis for “ABS”.
Is DTC detected?
YES>>
Check the DTC. Refer to DTC Index.
NO>>
GO TO 2.
CHECK PARKING BRAKE ACTUA ...
Moonroof Motor Assembly
Exploded View
Refer to Exploded View.
Removal and Installation
REMOVALCAUTION:
Before removing moonroof motor, check that glass lid is fully closed.
After removing moonroof motor, never attempt to rotate moonroof motor assembly as a single unit.
Remove headlining to make work space. Refer to Re ...
The Fuel Gauge Indicator Does Not Operate
Diagnosis Procedure
Fuel gauge will not indicate from a certain position.CONDUCTING THE COMBINATION METER SELF-DIAGNOSIS MODE
Perform the self-diagnosis mode of combination meter, and then check that the fuel gauge operates normally. Refer to On Board Diagnosis Function.
Is the inspection result no ...