Description
When replacing ECM, it is necessary to write MAC key to ECM. Write MAC key to ECM according to "MAC Key writing" procedure of "CONSULT Operation Manual". Refer to Work Procedure.
CAUTION:
During MAC key writing, maintain the following conditions:
-
Ignition switch ON
-
CONSULT is connected to internet
Work Procedure
PERFORM MAC KEY WRITING
-
Ignition switch ON.
-
Select "MAC Key writing" on “Work support” of "ECM" using CONSULT.
-
Touch "Write".
>>
INSPECTION END
Other materials
How to use the automatic brake hold function
Basic information
For optimal use of the Nissan Armada automatic brake hold system, follow the
operational guidelines outlined below to ensure safe and effective performance.
To maintain braking force automatically
When the Nissan Armada automatic brake hold function is active and the white
i ...
Additional Service When Replacing Transfer Control Unit
Description
When replacing transfer control unit, the following work is required. For the work procedure, refer to Work Procedure.WORK AFTER REPLACEMENT
Unit parameter writing
Initial calibration
Work Procedure
WRITING THE REQUIRED INFORMATION FOR CONTROL UNIT REPLACEMENT
With CONSULT
Ignitio ...
Rear Door Sash Inner Cover
Removal and Installation
CAUTION:
Never damage rear door panel.REMOVALRemove rear door finisher. Refer to Removal & Installation.
Remove inside seal according to numerical order 1→2 indicated by arrows as shown in the figure.
Apply protective tapes (A) on rear door panel to protect it from d ...