
![]() | Front output shaft | ![]() | Front oil seal | ![]() | Front case |
![]() | Snap ring | ![]() | Sprockets with chain | ![]() | Snap ring |
![]() | Rear case | ||||
![]() | : Always replace after every disassembly. | ||||
![]() | : N·m (kg-m, ft-lb) | ||||
![]() | : Apply transfer fluid. | ||||
![]() | : Apply Genuine Liquid Gasket, Loctite 598 or equivalent. | ||||
Front Oil Seal
Removal and InstallationLower Dash
WARNING:
Work after radiator core main support, side radiator core support, hoodledge, and upper dash are removed.
: Vehicle front
: Welding method and the number of welding points apply to both sides of the vehicle. Replacement part • Lower dash complete • Lower side dash assembly
Adhe ...
Removal and Installation
WARNING:
Always observe the following items for preventing accidental activation.
Before servicing, ignition switch OFF, disconnect battery negative terminal and wait for 3 minutes or more (discharges electricity held in the additional power supply circuit of the air bag diagnosis sensor unit). Refe ...
Change of System Mode
CAUTION:
When the following operations are performed, always use CONSULT, for performing "System mode change" of "Work support". Refer to Work Procedure.
×: Required —: not required
Procedure System mode change Removing/installing ABS actuator and electric unit (control unit) — Replacing ...