Front door regulator assembly is assembled on front door module assembly. Refer to Exploded View.
Removal and InstallationRemoval and Installation
CAUTION:
REMOVAL
Remove headlining assembly. Refer to Removal and Installation.
Disconnect harness connector.
Disengage vanity mirror lamp bracket fixing pawl using a remover tool (A) according to numerical order 1→2 indicated by arrows as shown in the figure, and then remove vanity mirror lamp an ...
Diagnosis Procedure
CHECK “AUTO DOOR UNLOCK” SETTING IN COMBINATION METER
Check “Auto Door Unlock” setting is “Shift to P”.
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Set “Shift to P” in combination meter.
REPLACE BCM
Replace BCM. Refer to Removal and Installation.
Confirm the op ...
Precautions for Removing Battery Terminal
NOTE:
NOTE:
NOTE:
The removal of 12V battery may cause a DTC detection error.
HOW TO DISCONNECT 12V BATTERY TERMINAL
Disconnect 12V battery terminal according to instruction described below.
Open the hood.
Turn ignition switch to the ON position.
Turn ignition switch to the OFF position with the d ...