Removal and Installation
CAUTION:
Never damage front door panel.
REMOVAL
Remove front door finisher. Refer to Removal & Installation.
Remove inside seal according to numerical order 1→2 indicated by arrows as shown in the figure.
Apply protective tapes (A) on front door panel to protect it from damage.
Disengage front door sash inner cover fixing clips using a remover tool (A).
 |
: Clip |
Remove front door sash inner cover according to numerical order 1→3 indicated by arrows as shown in the figure.
Disconnect tweeter harness connector, and then remove front door sash inner cover.
INSTALLATION
Note the following items, and then install in the reverse order of removal.
CAUTION:
-
Visually check clips for deformation and damage during installation. Replace with new ones if necessary.
-
Check in advance that clips are accurately aligned with the portions on front door panel, and then install by pressing in.
Other materials
Side Oil Seal
Exploded View
Rear final drive assembly
Side oil seal
: vehicle front
: Always replace after every disassembly.
Removal and Installation
WARNING:
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air su ...
Intelligent Key System All Functions Cannot Operate (all Keys)
Description
Intelligent Key system all functions cannot operate (door lock and engine start).SYMPTOM TABLE (BOTH INTELLIGENT KEYS HAVE THE SAME SYMPTOMS) Door lock operation (remote keyless entry) Door lock operation (one touch sensor or request switch of front/rear/back door) or trunk/back door op ...
Intelligent Key System Symptoms
Diagnosis Procedure
NOTE:
Perform the self-diagnosis with CONSULT before the symptom diagnosis. Perform the trouble diagnosis if any DTC is detected.SYMPTOM TABLE 1 (BOTH INTELLIGENT KEYS HAVE THE SAME SYMPTOMS) No. Door lock operation (remote keyless entry) Door lock operation (request switch of ...