Removal and Installation
REMOVAL
Remove front heater & cooling unit assembly. Refer to Removal and Installation.
Disconnect front air mix door motor (passenger side) harness connector 
.
Remove sub harness from front case lower assembly.
Remove cooler packing.
Remove fixing screws , and then remove heater pipe support.
Remove front heater core.
INSTALLATION
Note the following item, and then install in the reverse order of removal.
CAUTION:
Replace cooler packing with new one.
Other materials
Engine compartment check locations
Window washer fluid reservoir
Fuse/fusible link holder
Engine oil filler cap
Engine oil dipstick
Brake fluid reservoir
Battery
Engine coolant reservoir
Radiator filler cap
Drive belts
Air cleaner
VR35DDTT engine
NOTE:
Depending on the configuration of your Nissan Arma ...
Automatic Back Door Anti-Pinch Function Does Not Operate
Diagnosis Procedure
CHECK DTC WITH AUTOMATIC BACK DOOR CONTROL UNIT
Check that DTC is not detected with automatic back door control unit.
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Refer to DTC Index.
CHECK TOUCH SENSOR LH
Check touch sensor LH.
Refer to DTC Diagnosis Procedu ...
Additional Service When Replacing Av Control Unit
Work Procedure
DescriptionWhen AV control unit is replaced, AV control unit configuration is required.REPLACE AV CONTROL UNIT
Replace AV control unit. Refer to Removal & Installation.
>>
GO TO 2
PERFORM AV CONTROL UNIT PROGRAMMING & CONFIGURATION
CONSULT
Perform AV control unit progr ...