Removal and Installation
CAUTION:
Never reuse fuel filler base assembly. Always replace it with a new one when it is removed.
REMOVAL
Remove fuel filler lid. Refer to Removal and Installation.
Disengage fuel filler base mask 
fixing pawls using a remover tool (A) into drain hole 
, and then remove fuel filler base mask.
 |
: Pawl |
Drill holes at recessed parts 
of fuel filler base.
CAUTION:
-
Use a drill bit of Φ3.0 - 4.0 mm (Φ0.118 - 0.157 in) not to damage the vehicle body.
-
Never insert over 3.5 mm (0.138 in) from tip of drill bit not to break and/or damage pawl of fuel filler base assembly.
Insert a remover tool (B) into drill holes of fuel filler base assembly , and pull fuel filler base assembly to outside of vehicle while disengage fuel filler base assembly fixing pawls.
|
: Pawl |
NOTE:
-
Insert a removal tool into drill hole by approximately 12 mm (0.47 in) (C), and push down fixing pawl using principle of leverage.
-
It is easy to work with remover tool that has the same thickness as drill hole diameter.
Remove fuel filler base assembly from vehicle body according to the numerical order 1→2 indicated by arrows as shown in figure.
CAUTION:
Never damage vehicle body.
Remove fuel filler lid lock assembly. Refer to Removal and Installation.
INSTALLATION
Install fuel filler lid lock assembly. Refer to Removal and Installation.
Install fuel filler base assembly to vehicle body according to the numerical order 1→2 indicated by arrows as shown in figure.
CAUTION:
Never damage vehicle body.
Install fuel filler base to rear wheel outer panel LH 
and body side inner panel 
.
Install fuel filler base mask to fuel filler base.
Install fuel filler lid to fuel filler base assembly. Refer to Removal and Installation.
CAUTION:
After installation, check fuel filler base assembly open/close, lock/unlock operation.
Other materials
Remote engine start
Basic information
Example
The Nissan Armada remote engine start feature is activated using the dedicated
button on the Intelligent Key (if equipped), allowing the engine to be started conveniently
from outside the vehicle.
This advanced Nissan Armada functionality enhances comfort by en ...
Body Exterior Paint Color
Body Exterior Paint Color
FOR PRO-4X GRADE Component Color code BDAR BK23 BKAD BKH3
Description Grayish Green Silver Gray Black
Paint type note 2PM 2M 2M 2S
Anti scratch advanced paint × × × ×
Door mirror cover
Black
BKH3
BKH3
BKH3
BKH3
Door mirror finisher ...
Tail Lamp
Exploded View
Back door panel
Tail lamp LH
Grommet
Tail lamp RH
: Clip
: N·m (kg-m, in-lb)
Removal and Installation
CAUTION:
Disconnect the battery negative terminal or remove power circuit fuse when performing the operation for preventing electric ...