REMOVAL
Remove the luggage side finisher LH. Refer to Exploded View.
Disconnect fuel pump control module (FPCM) harness connector and remove the FPCM from the vehicle.
Remove bracket from fuel pump control module (FPCM).
INSTALLATION
Install in the reverse order of removal.
Install bracket
to fuel pump control module (FPCM)
, and install mounting screws
.
CAUTION:
Arrow mark
should face the fuel pump control module (FPCM) connector.

FUEL PUMP CONTROL MODULE (FPCM) : Exploded ViewDiagnosis Procedure
Description
Check that vehicle is under the condition shown in “Conditions of vehicle” before starting diagnosis, and check each symptom.
NOTE:
The engine start function, door lock function, power distribution system, and NATS-IVIS/NVIS in the Intelligent Key system are closely related to each o ...
Exploded View
Fuel filler base assembly Fuel filler lid Fuel filler lid lock assembly Fuel filler base mask : Pawl : Always replace after every disassembly. ...
Inspection
INSPECTION AFTER REMOVAL
Check dust boot clamp (looseness and disconnection) and dust boot (scratches, cracks, and holes). Replace the lower joint, as necessary.
Check each part of lower joint for damage and other malfunctions. Replace if there is a malfunction.
Check each part of steering shaft for ...