WARNING:
When replacing fuel line parts, be sure to observe the following.
Put a “CAUTION: FLAMMABLE” sign in the workshop.
CAUTION:
Use gasoline required by the regulations for octane number.Refer to Fuel..
Before removing fuel line parts, perform out the following procedures:
Put drained fuel in an explosion-proof container and put the lid on securely. Keep the container in safe area.
Release fuel pressure from the fuel lines. , Refer to Work Procedure.
Disconnect the battery cable from the negative terminal.
Always replace O-rings with new ones.
Never kink or twist tubes when they are being installed.
Never tighten hose clamps excessively to avoid damaging hoses.
After installing tubes, check there is no fuel leakage at connections in the following steps.
Apply fuel pressure to fuel lines with turning ignition switch “ON” (with engine stopped). Then check for fuel leakage at connections.
Start engine and rev it up and check for fuel leakage at connections.
Use only a genuine NISSAN fuel filler cap as a replacement. If an incorrect fuel filler cap is used, the “MIL” may come on.
For servicing “On Board Refueling Vapor Recovery (ORVR)”parts, Refer to On Board Refueling Vapor Recovery (ORVR).
PRECAUTIONS FOR REMOVING BATTERY TERMINAL : PrecautionsPrecautions for Removing Battery Terminal
NOTE:
NOTE:
NOTE:
The removal of 12V battery may cause a DTC detection error.
HOW TO DISCONNECT 12V BATTERY TERMINAL
Disconnect 12V battery terminal according to instruction described below.
Open the hood.
Turn ignition switch to the ON position.
Turn ignition switch to the OFF position with the d ...
Roof Rail
Work after roof is removed.
: Vehicle front : Drill φ8 mm (0.31 in) hole for the plug welding hole (ultra high strength steel). : Drill φ11 mm (0.43 in) hole for the plug welding hole (ultra high strength steel). : Weld the parts onto the back of the component part. : Welding method, the number o ...
Removal and Installation
REMOVAL
Remove A/T assembly from the vehicle. Refer to following :
2WD models: Refer to Removal and Installation.
4WD models: Refer to Removal and Installation.
Remove the drive plate using the following procedure:Secure crankshaft pulley with a pulley holder (A).
Loosen drive plate bolts and r ...