Additional Service When Replacing Hd Map Module
Work Procedure
When the following parts are replaced or removed, be sure to perform the specified incidental work in order to operate the system normally.
NOTE:
Since HD map module starts updating the map data from a position close to the own vehicle after replacement, it is not necessary to wait for completion of updating the map data.
CHECK ADAS CONTROL UNIT 2 REPLACEMENT
When HD map module and ADAS control unit 2 are replaced at the same time, the work for replacing ADAS control unit 2 is performed first.
Are HD map module and ADAS control unit 2 replaced at the same time?
YES>>Perform the replacement work for ADAS control unit 2 first. Refer to Work Procedure.
NO>>GO TO 2.
HD MAP MODULE CALIBRATION
Calibrate HD map module. Refer to Work Procedure.
>>
GO TO 3.
PERFORM SELF DIAGNOSIS
Check if DTC is detected as a result of self-diagnosis for "HD MAP".
Is DTC detected?
YES>>Perform a trouble diagnosis for detected DTC and repair or replace malfunctioning parts. Refer to DTC Index.
NO>>INSPECTION END
Hd Map Module Calibration
Work Procedure
When the following parts are replaced or removed, be sure to perform the specified incidental work in order to operate the system normally.
PREPARATION BEFORE CALIBRATION
-
Place the vehicle on a level surface.
-
Adjust all tire pressures to the specified pressure. Refer to TIRE AIR PRESSURE : Service Data.
>>
GO TO 2.
PERFORM CALIBRATION
With CONSULT
-
Start the engine.
-
Select "Work Support" in "HD MAP".
-
Select "HD map module calibration".
-
Select "START".
CAUTION:
Do not shake the vehicle while performing "HD map module calibration".
Is "Completed" message displayed?
YES>>WORK END
NO>>Perform steps 1 and 2 again.
Other materials
How to park with predictive course lines
WARNING
If non-standard tire sizes are installed on the Nissan Armada, the predictive
course lines may not display accurately.
On slippery or snow-covered roads, the Nissan Armada predicted path may
differ from the actual vehicle movement.
If the Nissan Armada battery is disconnected o ...
Low Tire Pressure Warning Lamp Does Not Turn Off
Description
The low tire pressure warning lamp does not turn OFF after several seconds is passed after engine starts.
Diagnosis Procedure
CHECK TIRE PRESSURE
Ignition switch ON.
CAUTION:
Never start the engine.
Check the tire pressure for all wheels and adjust to the specified value. Refer to TI ...
Front Air Conditioner
Description
Symptom
Insufficient cooling
No cool air comes out. (Air flow volume is normal.)
Diagnosis Procedure
NOTE:
Perform self-diagnoses with CONSULT before performing symptom diagnosis. If any DTC is detected, perform the corresponding diagnosis.CHECK MAGNET CLUTCH OPERATION
Ignition sw ...