NIARMADA Nissan Armada manuals & owner information
Nissan Armada owner resource

Manuals, service information and practical owner guidance.

Fast access to Nissan Armada manuals, operating instructions, maintenance references and technical information.

Browse manuals →
Nissan Armada manual library

Nissan Armada 2025-2026 Service and Repair Manual: Hood Lock Control Cable Assembly

Nissan Armada 2025-2026 Service and Repair Manual / Body Exterior, Doors, Roof & Vehicle Security / Door & Lock / Hood Lock / Hood Lock Control Cable Assembly

Removal and Installation

REMOVAL

Disconnect hood lock control cable assembly from hood lock assembly. Refer to Removal and Installation.

Disengage hood lock control cable assembly fixing clips.

Remove hood lock control handle. Refer to Removal and Installation.

Remove dash side finisher LH. Refer to Removal and Installation.

Remove hood lock control cable assembly mounting bolt.

Remove grommet of the lower dash, and pull the hood lock control cable assembly toward inside vehicle.

CAUTION:

  • While pulling, never damage (peeling) the outside of hood lock control cable assembly.

  • Pull out the hood lock control cable assembly while turning over the insulator around the grommet part of hood lock control cable assembly.

INSTALLATION

Note the following items, and then install in the reverse order of removal.

CAUTION:

  • Never bend cable too much, keeping the radius 100 mm (3.94 in) or more.

  • Install grommet in the panel hole surely.

  • Check that cable is not offset from the positioning grommet, and apply the sealant to the grommet properly.

  • After installation, perform hood lock control inspection. Refer to Inspection.

    Other materials

    Precautions for Supplemental Restraint System (srs) Air Bag and Seat Belt Pre-Te
    PRECAUTIONS FOR SUPPLEMENTAL RESTRAINT SYSTEM (SRS) AIR BAG AND SEAT BELT PRE-TENSIONER : Precautions The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front p ...

    Front Center Console Assembly
    Exploded View REMOVAL Front center console switch finisher assembly Front center console bracket Front center console side finisher upper LH Front center console side finisher lower LH Instrument lower cover LH Front center console mask LH Front center console rear finisher assemb ...

    Facial Recognition Check
    Work Procedure If system detects that driver is not facing forward even though driver is facing forward, perform face recognition check.PREPARATION BEFORE FACE RECOGNITION CHECK Make sure that all of the following conditions are satisfied vehicle speed is 0 km/h (stopped). Shift position is "P" ...