Diagnosis Procedure
CHECK “AUTO DOOR UNLOCK” SETTING IN COMBINATION METER
Check “Auto Door Unlock” setting is “Ignition OFF”.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Set “IGN OFF” in combination meter.
REPLACE BCM
-
Replace BCM. Refer to Removal and Installation.
-
Confirm the operation after replacement.
Is the result normal?
YES>>INSPECTION END
NO>>Check intermittent incident. Refer to Intermittent Incident.
Other materials
Precautions
Precautions for Removing Battery Terminal
When disconnecting the 12V battery terminal, turn off the ACC power before disconnecting the 12V battery terminal, observing “How to disconnect 12V battery terminal” described below.
NOTE:
Some ECUs operate for a certain fixed time even after ignit ...
Rear Air Conditioner
Description
Symptom
Insufficient cooling
No cool air comes out. (Air flow volume is normal.)
Diagnosis Procedure
NOTE:
Perform self-diagnoses with CONSULT before performing symptom diagnosis. If any DTC is detected, perform the corresponding diagnosis.CHECK REFRIGERANT CYCLE PRESSURE
Connect re ...
Cumulative Battery Discharge Current Clear
Description
CUMULATIVE BATTERY DISCHARGE CURRENT CLEAR is an operation to clear the cumulative value of battery discharge current which is memorized in IPDM E/R. This operation is necessary after replaced the 12V battery. Refer to Work Procedure.NOTE:
The cumulative battery discharge current value i ...