INSPECTION AFTER REMOVAL
Clean oil strainer if any object is attached.
INSPECTION AFTER INSTALLATION
Check the engine oil level and adjust engine oil. Refer to Inspection.
Start engine, and check there is no leakage of engine oil.
Stop engine and wait for 10 minutes.
Check the engine oil level again. Refer to Inspection.
Removal and Installation
Oil Pan (upper)Removal and Installation
REMOVAL
Remove front seatback trim and pad. Refer to Disassembly and Assembly.
Disengage fixing pawls and then remove front seatback blower motor.
: Pawl
Disengage front seatback blower motor harness fixing clip.
Disconnect front seatback blower motor connector and then remove front seatback blow ...
Exploded View
Rear final drive assembly Side oil seal : Vehicle front : Always replace after every disassembly. ...
Removal & Installation
WARNING:
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the Vehicle with Electronic Air Suspension System.
When checking under the vehicle or in ...