Nissan Armada 2025-2026 Service and Repair Manual: Inspection
INSPECTION AFTER REMOVAL
Clean oil strainer if any object is attached.
INSPECTION AFTER INSTALLATION
Check the engine oil level and adjust engine oil. Refer to Inspection.
Start engine, and check there is no leakage of engine oil.
Stop engine and wait for 10 minutes.
Check the engine oil level again. Refer to Inspection.
Disassembly and Assembly
WARNING:
REMOVAL
CAUTION:
Never drain engine oil when the engine is hot to avoid the danger of being scalded.
Remove main muffler. Refer to EXHAUST SYSTEM : Removal & Installation.
Remove front pr ...
Catalyst
...
Other materials:
Diagnosis Procedure
PERFORM SELF-DIAGNOSIS OF DISPLAY UNIT
Perform “Self Diagnostic Result” of “Display unit”.
Is DTC detected?
YES>>
Perform diagnosis procedure on the detected DTC. Refer to DTC Index.
NO>>
GO TO 2.
PERFORM SELF-DIAGNOSIS OF COMBINATION METER
Perform “Self Diagnostic Result” ...
Work Procedure
DESCRIPTION
When replacing the power steering control module, the procedures of AFTER REPLACEMENT must be performed.
AFTER REPLACEMENT
After replacing the power steering control module, the following items must be performed:
Power steering control module programming.
Power steering control module co ...
Exploded View
Front output shaft Front oil seal Front case Snap ring Sprockets with chain Snap ring Rear case : Always replace after every disassembly. : N·m (kg-m, ft-lb) : Apply transfer fluid. : Apply Genuine Liquid Gasket, Loctite 598 or equivalent. ...
0.0055