Nissan Armada 2025-2026 Service and Repair Manual: Inspection
WARNING:
FRONT DRIVE SHAFT INSPECTION
Check the following items, and replace the part if necessary.
Check drive shaft mounting point and joint for looseness and other damage.
CAUTION:
Replace entire drive shaft assembly when noise or vibration occur from drive shaft.
Check boot for cracks and other damage.
Other materials:
Removal and Installation
CAUTION:
REMOVAL
Remove headlining assembly. Refer to Removal and Installation.
Disconnect harness connector.
Disengage rear room lamp bracket fixing pawls using a remover tool (A), and then remove rear room lamp and rear room lamp bracket.
: Pawl : Vehicle front
INSTALLATION
Install in the re ...
Crush Horn
WARNING:
Unit: mm (in) : Vehicle front Replacement part • Front side member assembly • 1st cab mounting bracket assembly • Front side member closing assembly (Front) ...
Calibration of Decel G Sensor
TCM stores calibration data (inherent characteristic value) of decel G sensor to provide accurate control.
Decel G sensor calibration must be performed when the following operation is performed. For work procedure, refer to Work Procedure.
Removing/Installing yaw rate/side/decel G sensor
Replacing y ...
0.0049