Work Procedure
CHECK START
-
In the cool LED status (wait for more than 10 minutes after turning headlamp OFF), turn ON and turn OFF headlamp for the several times. Check that headlamp operates normally each time.
-
In the cool LED status, turn headlamp ON, wait until headlamp enters to the stable status (approximately 5 minutes after turning headlamp ON), and then check that headlamp operates normally without blinking or flickering.
-
In the warm LED status (turn headlamp ON for more than 15 minutes and wait for 1 minute after turning OFF), turn ON and turn OFF headlamp for the several times. Check that headlamp operates normally each time.
-
Turn headlamp ON for approximately 30 minutes, and then check that headlamp operates normally without difference in brightness between LH and RH, blinking or flickering.
Is the inspection result normal?
YES>>INSPECTION END
NO>>Refer to Symptom Table.
Other materials
Rear Wheel Hub and Housing
Inspection
WARNING:
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
MOUNTING INSPECTIONC ...
Sensor Rotor
Front Sensor Rotor
Removal and Installation
WARNING:
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspensio ...
Radiator Core Support
Removal and Installation
REMOVALRemove radiator air guide upper. Refer to Removal and Installation.
Remove front combination lamp. Refer to Removal and Installation.
Remove active grille shutter upper side mounting bolts. Refer to Removal and Installation.
Remove hood lock assembly. Refer to Removal ...