Removal and Installation
CAUTION:
Never damage the body panel.
REMOVAL
CAUTION:
When removing, always use a remover tool that is made of plastic to prevent damage to the parts.
Remove rear pillar finisher. Refer to Removal and Installation.
Remove back pillar garnish. Refer to Removal and Installation.
Apply protective tape (A) on luggage side upper finisher to protect it from damage.
| : vehicle front |
Disengage bolt cap fixing pawls using a remover tool (A), and then remove bolt cap.
 |
: Pawl |
| : vehicle front |
Remove luggage side upper finisher mounting bolt.
Disengage luggage side upper finisher fixing clips using a remover tool (A), and then remove luggage side upper finisher.
 |
: Clip |
| : vehicle front |
INSTALLATION
Note the following items, and then install in the reverse order of removal.
CAUTION:
-
Visually check clips for deformation and damage during installation. Replace with new ones if necessary.
-
Check in advance that clips are accurately aligned with the portions on body panel, and then install by pressing in.
Other materials
Hill descent control system
Basic information
WARNING
Do not rely solely on the Hill Descent Control system in the Nissan Armada
to regulate speed on steep downhill slopes. Always maintain full control of
the vehicle and use the brake pedal when necessary. Extra caution is required
on slippery, muddy, icy, or ext ...
Service After Replacing or Removing Engine Parts
Description
×:Applicable Part name Service performed Service Manual item Reference
Replacement Removal
ECM
×
—
Additional service when replacing ECM
Refer to Work Procedure.
Accelerator pedal position sensor
×
×*1
Accelerator pedal released position learning
Refer to ...
Back Door Lower Finisher
Removal and Installation
CAUTION:
Never damage the back door panel.REMOVALCAUTION:
When removing, always use a remover tool that is made of plastic to prevent damage to the parts.Remove back door pull handle. Refer to Removal and Installation.
Remove back door finisher cap (without automatic back do ...