Description
The parking, license plate, side marker and tail lamps are not turned ON in any condition.
Diagnosis Procedure
COMBINATION SWITCH INSPECTION
Check combination switch. Refer to Symptom Table.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Repair or replace the malfunctioning part.
CHECK POSITION LIGHT REQUEST SIGNAL
With CONSULT
-
Select “Position light request” in “Data Monitor” mode of “IPDM E/R” using CONSULT.
-
With operating the lighting switch, check the monitor status.
Monitor item Condition Monitor status Position light request Lighting switch 1ST On OFF or AUTO* Off *: Only when the illumination judgement by auto light function is OFF.
Is the inspection result normal?
YES>>Replace IPDM E/R. Refer to Removal and Installation.
NO>>Replace BCM. Refer to Removal and Installation.
Other materials
RearView Monitor system operation
The Nissan Armada RearView Monitor system utilizes a rear-mounted camera 1, positioned
just above the license plate, to provide a clear and wide-angle view behind the
vehicle.
To activate the Nissan Armada RearView Monitor, turn the ignition switch to the
ON position and shift the transmi ...
Readiness for Inspection/Maintenance (I/M) test
WARNING
A Nissan Armada equipped with Four-Wheel Drive (4WD) must never be tested
on a two-wheel dynamometer or similar equipment used in some emissions testing facilities.
Always inform inspection personnel that your Nissan Armada is a 4WD vehicle
before testing begins.
Using incorrect testi ...
Configuration (combination Meter)
Description
Vehicle specification needs to be written with CONSULT because it is not written after replacing the combination meter.The configuration requires network connection. CONSULT connects to network and then it downloads the configuration data from the server. Then CONSULT writes the vehicle ...