Description
Both side headlamps (LO) are not turned ON in any condition.
Diagnosis Procedure
COMBINATION SWITCH INSPECTION
Check combination switch. Refer to Symptom Table.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Repair or replace the malfunctioning part.
CHECK LOW BEAM REQUEST SIGNAL
With CONSULT
-
Select “Low beam request” in “Data Monitor” mode of “IPDM E/R” using CONSULT.
-
With operating the lighting switch, check the monitor status.
Monitor item Condition Monitor status Low beam request Lighting switch 2ND On OFF or AUTO* Off *: Only when the illumination judgement by auto light function is OFF.
Is the inspection result normal?
YES>>Replace IPDM E/R. Refer to Removal and Installation.
NO>>Replace BCM. Refer to Removal and Installation.
Other materials
A/t Fluid Cooler
Exploded View
Bracket
A/T fluid cooler air guide RR
A/T fluid cooler
A/T fluid cooler air guide FR
Bracket
: N·m (kg-m, ft-lb)
: N·m (kg-m, in-lb)
Removal and Installation
WARNING:
Jacking up or lift up the vehicle may the vehicle height to go down which c ...
Diagnosis and Repair Work Flow
Work Flow
DETAILED FLOWINTERVIEW FROM THE CUSTOMER
Clarify customer complaints before inspection. First of all, perform an interview utilizing Diagnostic Work Sheet and reproduce symptoms as well as fully understand it. Ask customer about his/her complaints carefully. Check symptoms by driving vehic ...
Steering Assist Switch
Removal & Installation
REMOVALRemove instrument pad A. Refer to Removal and Installation.
Remove mounting screws , and remove switch panel from instrument pad A .
Unhook the pawls to remove the switch from the switch panel .
INSTALLATIONInstallation is in the reverse order of removal. ...