Removal and Installation
CAUTION:
Never bend the pawl of power window switch finisher.
REMOVAL
-
Remove front door finisher (passenger side). Refer to Removal & Installation.
-
Disengage door lock and unlock switch (passenger side) fixing pawls using a remover tool (A), and then remove door lock and unlock switch (passenger side)
from the power window switch finisher (passenger side).
: Pawl 
INSTALLATION
Installation is in the reverse order of removal.
Other materials
Noise, Vibration and Harshness (nvh) Troubleshooting
NVH Troubleshooting Chart
Use chart below to find the cause of the symptom. If necessary, repair or replace these parts. Possible cause and SUSPECTED PARTS Symptom Reference
FRONT AXLE
Noise Shake Vibration Shimmy Judder Poor quality ride or handling
Improper installation, looseness
...
Ign Off Interlock Door Unlock Function Does Not Operate
Diagnosis Procedure
CHECK “AUTO DOOR UNLOCK” SETTING IN COMBINATION METER
Check “Auto Door Unlock” setting is “Ignition OFF”.
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Set “IGN OFF” in combination meter.
REPLACE BCM
Replace BCM. Refer to Removal and Install ...
Both Sides
Diagnosis Procedure
CHECK DOOR MIRROR DEFOGGER
Check door mirror defogger. Refer to Component Function Check.
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Repair or replace the malfunctioning parts.
CONFIRM THE OPERATION
Confirm the operation again.
Is the inspection result nor ...