WARNING:
Brake fluid use refer to Fluids and Lubricants.
Never reuse drained brake fluid.
Always confirm the specified tightening torque when installing the brake pipes.
After pressing the brake pedal more deeply or harder than normal driving, such as air bleeding, check each item of brake pedal. Adjust brake pedal if it is outside the standard value.
Never use mineral oils such as gasoline or light oil to clean. They may damage rubber parts and cause improper operation.
Always loosen the brake tube flare nut with a flare nut wrench.
Tighten flare nut of brake tube to the specified torque using a flare nut torque wrench (A).

Ignition switch OFF and disconnect the ABS actuator and electric unit (control unit) harness connector or the 12V battery negative terminal before performing the work. Refer to Precautions for Removing Battery Terminal.
Check that no brake fluid leakage is present after replacing the parts.
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
Precaution for Brake Control SystemRefilling
WARNING:
IN CASE REPLACING OR REMOVING AND INSTALLING ELECTRICAL BRAKE CONTROL UNIT
Regarding brake fluid draining, refer to Work Procedure.
IN CASE NOT REPLACING OR REMOVING AND INSTALLING ELECTRICAL BRAKE CONTROL UNIT
CAUTION:
Check that there is no foreign material in the reservoir tank, and refi ...
Removal and Installation
REMOVAL
WARNING:
CAUTION:
Never removal and install air suspension control module by holding air suspension control module harness.
Start engine.
Turn OFF the electronic air suspension function. Refer to Operation.
Stop engine.
Lift up the vehicle.
Remove rear LH tire. Refer to ROAD WHEEL TIRE : R ...
Exploded View
Crankshaft position sensor Dowel pin Drive plate : N·m (kg-m, ft-lb) : N·m (kg-m, in-lb) ...