Solder the repair part, and wrap it with tape. [Twisted wire fray must be 110 mm (4.33 in) or less.]

Never bypass the repair point with wire. (If it is bypassed, the turnout point cannot be separated and the twisted wire characteristics are lost.)

Precautions for Removing Battery Terminal
Wiring DiagramRemoval and Installation
REMOVAL
Remove rear bumper fascia. Refer to Removal and Installation.
Remove bracket cover fixing screws, and then remove bracket cover.
Disconnect hands free sensor harness connectors.
Remove hands free control unit fixing screws, and then remove hands free control unit.
Remove hands free sensor up ...
Diagnosis Procedure
CHECK “AUTO DOOR UNLOCK” SETTING IN COMBINATION METER
Check “Auto Door Unlock” setting is “Ignition OFF”.
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Set “IGN OFF” in combination meter.
REPLACE BCM
Replace BCM. Refer to Removal and Installation.
Confirm the ope ...
Disassembly and Assembly
CAUTION:
OUTSIDE SEAT CUSHION FINISHER OUTER
Disassembly
Disengage fixing pawls, and then remove reclining knob cap.
: Pawl
Disengage fixing portion using a remover tool (A) according to numerical order 1→2 indicated by arrows as shown in the figure, and then remove reclining knob.
Remove ...