Nissan Armada 2025-2026 Service and Repair Manual: Precautions for Removing Battery Terminal
NOTE:- NOTE:
- NOTE:
The removal of 12V battery may cause a DTC detection error.
HOW TO DISCONNECT 12V BATTERY TERMINAL
Disconnect 12V battery terminal according to instruction described below.
Open the hood.
Turn ignition switch to the ON position.
Turn ignition switch to the OFF position with the driver side door opened.
Get out of the vehicle and close the driver side door.
BR08DE : 4 minutes R9N engine : 12 minutes BR10DE : 12 minutes V9X engine : 4 minutes D4D engine : 20 minutes YD25DDTi : 2 minutes HR09DET : 12 minutes YS23DDT : 4 minutes HR10DDT : 12 minutes YS23DDTT : 4 minutes HR10DET : 12 minutes ZD30DDTi : 60 seconds HR13DDT : 12 minutes ZD30DDTT : 60 seconds HRA2DDT : 12 minutes K9K engine : 4 minutes M9R engine : 4 minutes R9M engine : 4 minutes CAUTION:
Remove 12V battery terminal.
CAUTION:
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front pas ...
Precaution for Harness Repair
Solder the repair part, and wrap it with tape. [Twisted wire fray must be 110 mm (4.33 in) or less.]
Never bypass the repair point with wire. (If it is bypassed, the turnout point cannot be separated ...
Other materials:
Removal and Installation
REMOVAL
Remove instrument panel assembly. Refer to Removal and Installation.
Disconnect intake door motor harness connector .
Remove fixing screws , and then remove intake door motor.
INSTALLATION
Install in the reverse order of removal. ...
Work Support
For each work support, follow the procedure shown in CONSULT.
The table below shows the additional explanations provided in the CONSULT.
CAUTION:
At the end of the work, be sure to perform a “Vehicle height adjustment” and adjust the vehicle to NORMAL height before returning it to the customer.
...
Precautions for Removing Battery Terminal
NOTE:
NOTE:
NOTE:
The removal of 12V battery may cause a DTC detection error.
HOW TO DISCONNECT 12V BATTERY TERMINAL
Disconnect 12V battery terminal according to instruction described below.
Open the hood.
Turn ignition switch to the ON position.
Turn ignition switch to the OFF position with the d ...
0.0062