PRECAUTIONS FOR POP UP ENGINE HOOD : Precautions
WARNING:
Always observe the following items for preventing accidental activation.
-
Before removal or installation of the pop-up engine hood and harness, always OFF the ignition switch, disconnect the battery negative terminal, and wait for 3 minutes or more. (To discharge the accumulated electricity in the control unit auxiliary power supply circuit)
-
Never use pneumatic or electric tools, etc., to remove or install components of the pop-up engine hood.
-
Never repair the harness for the pop-up engine hood with a solder. Also, always avoid contact or interference between the harness and other parts.
-
Never use an electric tester like a circuit tester, etc., when inspecting the pop-up engine hood circuit or other individual parts. (To prevent activation due to the low voltage of the tester)
-
Never allow foreign materials like a screwdriver, etc., to enter the pop-up engine hood harness connector. (To prevent activation due to static electricity)
-
The yellow harness connector is used with the pop-up engine hood actuator for identification purposes compared to other harnesses.
Other materials
Water Outlet and Water Piping
Exploded View
Water hose 1
Clamp
Water hose 2
Water pipe 1
Water hose 3
Electric water pump
Bracket
Clip
Water hose 4
Drain plug
O-ring
Connector
Clip
Water hose 5
Water pipe 2
Gasket
Water hose 6
Water hose 7
Water pipe assembly
...
Exhaust System
Exploded View
Mounting rubber 1
Main muffler
Mounting rubber 2
Gasket
Mounting bracket
Mounting rubber 3
Rear muffler
Mounting rubber 4
To catalyst. Refer to Exploded View.
: N·m (kg-m, ft-lb)
: Always replace after every ...
System Initialization
Description
Initialization of system should be conducted after the following conditions. Refer to Work Procedure.
When the moonroof motor assembly or sunshade motor assembly is replaced.
When the moonroof or sunshade does not operate normally. (Incomplete initialization conditions)
Work Procedu ...