Nissan Armada 2025-2026 Service and Repair Manual: PRECAUTIONS FOR POP UP ENGINE HOOD : Precautions
WARNING:
Always observe the following items for preventing accidental activation.
Before removal or installation of the pop-up engine hood and harness, always OFF the ignition switch, disconnect the battery negative terminal, and wait for 3 minutes or more. (To discharge the accumulated electricity in the control unit auxiliary power supply circuit)
Never use pneumatic or electric tools, etc., to remove or install components of the pop-up engine hood.
Never repair the harness for the pop-up engine hood with a solder. Also, always avoid contact or interference between the harness and other parts.
Never use an electric tester like a circuit tester, etc., when inspecting the pop-up engine hood circuit or other individual parts. (To prevent activation due to the low voltage of the tester)
Never allow foreign materials like a screwdriver, etc., to enter the pop-up engine hood harness connector. (To prevent activation due to static electricity)
The yellow harness connector is used with the pop-up engine hood actuator for identification purposes compared to other harnesses.
Other materials:
When SRS is not activated in a collision
CAUTION:
WORK PROCEDURE
Check the SRS components using the table below.
Ensure entire SRS operates properly.
SRS INSPECTION (FOR REAR COLLISION)
Part Inspection Driver air bag module If the driver air bag has not been activated:
Remove driver air bag module. Check harness cover and connectors fo ...
Diagnosis Procedure
CAUTION:
VDC function, ABS function and EBD function never operate when the vehicle speed is 10 km/h (6.2 MPH) or less.
CHECK WARNING LAMP
Check that ABS warning lamp and VDC warning lamp turn ON and turn OFF several seconds after ignition switch is ON or driving.
Check that brake warning lamp turn ...
Work Procedure
START
With CONSULT
Ignition switch ON.
On CONSULT screen, select “ECM”>>“Work support”>>“Close throttle position learning”.
Follow the instructions on the CONSULT display.
Ignition switch OFF and wait at least 10 seconds.
Check that throttle valve moves during the above 10 se ...
0.0054