Chevrolet Sonic manuals

Nissan Armada 2025-2026 Service and Repair Manual: Work Procedure

START

With CONSULT

  1. Ignition switch ON.

  2. On CONSULT screen, select “ECM”>>“Work support”>>“Close throttle position learning”.

  3. Follow the instructions on the CONSULT display.

  4. Ignition switch OFF and wait at least 10 seconds.

  5. Check that throttle valve moves during the above 10 seconds by confirming the operating sound.

Without CONSULT

  1. Start the engine.

    NOTE:

    Coolant temperature is less than 25°C (77°F) before engine starts.

  2. Warm up the engine until engine coolant temperature reaches 65°C (149°F).

  3. Ignition switch OFF and wait at least 10 seconds.

  4. Check that throttle valve moves during the above 10 seconds by confirming the operating sound.

>>

END

Throttle Valve Closed Position Learning
Throttle Valve Closed Position Learning is a function of ECM to learn the fully closed position of the throttle valve by monitoring the throttle position sensor output signal. It must be performed eac ...

Wastegate Valve Closed Position Learning
Wastegate valve closed position learning is a function of ECM to learn the fully closed position of the wastegate valve by monitoring the wastegate valve position sensor output signal. It must be perf ...

Other materials:

Removal and Installation
REMOVAL Remove front heater & cooling unit assembly and front blower unit assembly. Refer to Removal and Installation. Disconnect front mode door motor harness connector . Remove fixing screws , and then remove front mode door motor. INSTALLATION Install in the reverse order of removal. ...

Exploded View
Radiator Condenser outlet pipe O-ring Condenser & liquid tank assembly Condenser seal Refrigerant pressure sensor Condenser inlet pipe : Pawl : Always replace after every disassembly. : N·m (kg-m, in-lb) , , : Indicates that the part is connected at points with same symbol in actual v ...

Inspection
WARNING: BRAKE FLUID LEVEL Check that the brake fluid level in the reservoir tank is within the standard (between MAX − MIN lines). Visually check for any brake fluid leakage around the reservoir tank. Check the brake system for any leakage if the fluid level is extremely low (lower than MIN). Ch ...

© 2014-2026 Copyright www.niarmada.com
 
0.0051