Nissan Armada 2025-2026 Service and Repair Manual: Precautions for Removing Battery Terminal
NOTE:- NOTE:
- NOTE:
The removal of 12V battery may cause a DTC detection error.
HOW TO DISCONNECT 12V BATTERY TERMINAL
Disconnect 12V battery terminal according to instruction described below.
Open the hood.
Turn ignition switch to the ON position.
Turn ignition switch to the OFF position with the driver side door opened.
Get out of the vehicle and close the driver side door.
BR08DE : 4 minutes R9N engine : 12 minutes BR10DE : 12 minutes V9X engine : 4 minutes D4D engine : 20 minutes YD25DDTi : 2 minutes HR09DET : 12 minutes YS23DDT : 4 minutes HR10DDT : 12 minutes YS23DDTT : 4 minutes HR10DET : 12 minutes ZD30DDTi : 60 seconds HR13DDT : 12 minutes ZD30DDTT : 60 seconds HRA2DDT : 12 minutes K9K engine : 4 minutes M9R engine : 4 minutes R9M engine : 4 minutes CAUTION:
Remove 12V battery terminal.
CAUTION:
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
WARNING:
Always observe the following items for preventing accidental activation.
PRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS
WARNING:
Always observe the following items for preve ...
Precaution for when Jacking and Lifting Up the Vehicle with Electronic Air Suspension
System
WARNING:
CAUTION:
OPERATION PROCEDURE
Jacking up or lift up using the following steps.
Start engine.
Turn OFF the electronic air suspension function. Refer to Operation.
Stop engine.
Jacking up or lif ...
Other materials:
Removal and Installation
REMOVAL
Remove combination meter. Refer to Removal and Installation.
Remove mounting screw , and remove bracket .
Remove mounting nuts , and remove ADAS control unit 2 from steering member .
Disconnect ADAS control unit 2 connector.
Remove mounting nuts , and remove ADAS control unit 2 from br ...
Symptom Description
SYSTEM UNIT
LIQUID CRYSTAL DISPLAY Symptom Possible cause Possible solution The screen is too dark. The cabin temperature is too low. Wait until the cabin temperature becomes moderate. The cabin temperature is too hot. Screen brightness is set to the maximum darkness. Adjust the brightness s ...
Removal and Installation
WARNING:
REMOVAL
Water pipe 1
Remove engine cover. Refer to Removal and Installation.
Drain engine coolant. Refer to ENGINE COOLANT : Draining.
CAUTION:
Perform this step when the engine is cold.
Remove air inlet tube 1. Refer to Removal & Installation.
Remove water hose 2 and water hose 3 fr ...
0.0048