Nissan Armada 2025-2026 Service and Repair Manual: Precautions for Removing Battery Terminal

Nissan Armada 2025-2026 Service and Repair Manual / Restraints / Seat Belt Control System — Precaution / Precautions / Precautions for Removing Battery Terminal

NOTE:
NOTE:
NOTE:

The removal of 12V battery may cause a DTC detection error.

HOW TO DISCONNECT 12V BATTERY TERMINAL

Disconnect 12V battery terminal according to instruction described below.

Open the hood.
Turn ignition switch to the ON position.
Turn ignition switch to the OFF position with the driver side door opened.
Get out of the vehicle and close the driver side door.

BR08DE	: 4 minutes	R9N engine	: 12 minutes
BR10DE	: 12 minutes	V9X engine	: 4 minutes
D4D engine	: 20 minutes	YD25DDTi	: 2 minutes
HR09DET	: 12 minutes	YS23DDT	: 4 minutes
HR10DDT	: 12 minutes	YS23DDTT	: 4 minutes
HR10DET	: 12 minutes	ZD30DDTi	: 60 seconds
HR13DDT	: 12 minutes	ZD30DDTT	: 60 seconds
HRA2DDT	: 12 minutes	K9K engine	: 4 minutes
M9R engine	: 4 minutes	R9M engine	: 4 minutes

CAUTION:

Remove 12V battery terminal.

CAUTION:

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"

WARNING: Always observe the following items for preventing accidental activation. PRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS WARNING: Always observe the following items for preve ...

Seat Belt Control System — Wiring Diagram

...

Other materials:

Removal and Installation
CAUTION: Perform work with 2 workers, because it is heavy weight. Support door with a proper material and use protective tape or shop cloth to protect door and body from falling and damage when removing and installing door assembly. REMOVAL Remove front door check link mounting bolt of vehicle body ...

Removal and Installation
CAUTION: Never damage the body panel. REMOVAL CAUTION: Remove luggage rear plate. Refer to Removal and Installation. Release luggage side lower finisher portion of back door weather-strip. Refer to Removal and Installation. Set second seat to walk-in position. Remove third seat. Refer to Removal and ...

Work Procedure
WRITING VEHICLE SPECIFICATION With CONSULT Perform writing vehicle specification to ABS actuator and electric unit (control unit) following "Automatic Configuration" procedure of "Configuration" according to CONSULT Operation Manual. NOTE: Log in the network according to CONSULT guidance. >> ...

0.0048