
NOTE:
NOTE:
NOTE:
The removal of 12V battery may cause a DTC detection error.
HOW TO DISCONNECT 12V BATTERY TERMINAL
Disconnect 12V battery terminal according to instruction described below.
Open the hood.
Turn ignition switch to the ON position.
Turn ignition switch to the OFF position with the driver side door opened.
Get out of the vehicle and close the driver side door.
| BR08DE | : 4 minutes | R9N engine | : 12 minutes |
| BR10DE | : 12 minutes | V9X engine | : 4 minutes |
| D4D engine | : 20 minutes | YD25DDTi | : 2 minutes |
| HR09DET | : 12 minutes | YS23DDT | : 4 minutes |
| HR10DDT | : 12 minutes | YS23DDTT | : 4 minutes |
| HR10DET | : 12 minutes | ZD30DDTi | : 60 seconds |
| HR13DDT | : 12 minutes | ZD30DDTT | : 60 seconds |
| HRA2DDT | : 12 minutes | K9K engine | : 4 minutes |
| M9R engine | : 4 minutes | R9M engine | : 4 minutes |
CAUTION:
Remove 12V battery terminal.
CAUTION:
Precautions
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"Removal and Installation
REMOVAL
Remove luggage side lower finisher LH. Refer to Removal and Installation.
Disconnect back door auto closure control unit harness connector.
Remove back door auto closure control unit mounting nuts , and then remove back door auto closure control unit .
INSTALLATION
Install in the reverse o ...
Removal and Installation
REMOVAL
2WD Models
Remove glove box assembly. Refer to Removal and Installation.
Remove passenger knee air bag module. Refer to Removal and Installation.
Disconnect A/C auto amp. harness connectors and .
: Vehicle front
Remove fixing screw , and then slide A/C auto amp. in the direction indica ...
Diagnosis Procedure
CHECK SELF-DIAGNOSTIC RESULTS
With CONSULT
Perform self-diagnosis for “DIFFERENTIAL LOCK”.
Is any DTC detected by self-diagnosis?
YES>>
Check the malfunctioning system. Refer to DTC Index.
NO>>
GO TO 2.
CHECK DIFFERENTIAL LOCK MODE SWITCH OPERATION
Check differential lock mode swit ...