Nissan Armada 2025-2026 Service and Repair Manual: Precautions for Removing Battery Terminal

Nissan Armada 2025-2026 Service and Repair Manual / Body Exterior, Doors, Roof & Vehicle Security / Roof — Precaution / Precautions / Precautions for Removing Battery Terminal

NOTE:
NOTE:
NOTE:

The removal of 12V battery may cause a DTC detection error.

HOW TO DISCONNECT 12V BATTERY TERMINAL

Disconnect 12V battery terminal according to instruction described below.

Open the hood.
Turn ignition switch to the ON position.
Turn ignition switch to the OFF position with the driver side door opened.
Get out of the vehicle and close the driver side door.

BR08DE	: 4 minutes	R9N engine	: 12 minutes
BR10DE	: 12 minutes	V9X engine	: 4 minutes
D4D engine	: 20 minutes	YD25DDTi	: 2 minutes
HR09DET	: 12 minutes	YS23DDT	: 4 minutes
HR10DDT	: 12 minutes	YS23DDTT	: 4 minutes
HR10DET	: 12 minutes	ZD30DDTi	: 60 seconds
HR13DDT	: 12 minutes	ZD30DDTT	: 60 seconds
HRA2DDT	: 12 minutes	K9K engine	: 4 minutes
M9R engine	: 4 minutes	R9M engine	: 4 minutes

CAUTION:

Remove 12V battery terminal.

CAUTION:

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"

WARNING: Always observe the following items for preventing accidental activation. PRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS WARNING: Always observe the following items for preve ...

Roof — Preparation

...

Other materials:

Normal Operating Condition
Symptom Possible cause Unstable object detection The vehicle is on a rough surface, such as stone or gravel. When used in poor weather conditions, such as heavy snow/rain or strong wind. When subjected to an ultrasonic noise generated from exhaust muffler or brakes. When left standing in the hot ...

Removal and Installation
WARNING: Always observe the following items for preventing accidental activation. Before servicing, ignition switch OFF, disconnect 12V battery negative terminal and wait for 3 minutes or more (discharges electricity held in the additional power supply circuit of the air bag diagnosis sensor unit). ...

Inspection and Adjustment
WARNING: INSPECTION Check brake pad wear thickness from an inspection hole on cylinder body. Check using a scale if necessary. Wear thickness : Refer to Front Disc Brake. ADJUSTMENT Burnish contact surfaces between disc rotor and brake pads according to the following procedure after refinishing ...

0.005