Nissan Armada 2025-2026 Service and Repair Manual: Inspection and Adjustment
WARNING:
INSPECTION
Check brake pad wear thickness from an inspection hole on cylinder body. Check using a scale if necessary.
| Wear thickness | : Refer to Front Disc Brake. |
ADJUSTMENT
Burnish contact surfaces between disc rotor and brake pads according to the following procedure after refinishing or replacing brake pads, or if a soft pedal occurs at very low mileage.
CAUTION:
Be careful of vehicle speed because the brake does not operate firmly/securely until pads and disc rotor are securely fitted.
Only perform this procedure under safe road and traffic conditions. Use extreme caution.
Drive vehicle on straight, flat road.
Depress brake pedal with the power to stop vehicle within 3 to 5 seconds until the vehicle stops.
Drive without depressing brake for a few minutes to cool the brake.
Repeat steps 1 to 3 until pad and disc rotor are securely fitted.
Brake Pad
...
Disc Rotor
...
Other materials:
How To Check
If fuse is blown, be sure to eliminate cause of malfunction before installing new fuse.
Use fuse of specified rating. Never use fuse of more than specified rating.
Do not partially install fuse; always insert it into fuse holder properly.
Remove fuse for “ELECTRICAL PARTS (BAT)” if vehicle is n ...
Removal and Installation
REMOVAL
CAUTION:
Before removing, take a short memo/photo to remember door harness and cable layout.
Rear Door Inner Frame Front
Remove pull handle bracket. Refer to Removal and Installation.
Apply protective tapes (A) on the part to protect it from damage.
Disengage fixing clips by using removal ...
Exploded View
Bank 1 side
Ignition coil Spark plug Rocker cover Rocker cover gasket Blow-by hose 1 (bank 1) Clamp Blow-by hose 2 (bank 1) Intake camshaft position sensor Exhaust camshaft position sensor Crankcase pressure sensor Comply with the installation procedure when tightening. Refer to Removal ...
0.0071